Peavey Triumph PAG 60 - Page 7

SPECIFICATIONS
(continued)
Preamp High Gain Input:
Impedance: Very high Z,
470 K ohm
Ultra Channel:
(with channel-select in)
Nominal Input Level: -46 dBV,
5 mV RMS
Minimum Input Level: -64 dBV,
0.6 mV RMS
(Subtract 15 dB with gain
switch in)
Crunch Channel:
(footswitch selected)
Nominal Input Level: -34 dBV,
20 mV RMS
Minimum Input Level: -52 dBV,
2.5 mV RMS
(Subtract 15 dB with gain
switch in)
Clean Channel:
(with channel-select out)
Nominal Input Level: -16 dBV,
150 mV RMS
Minimum Input Level: -34 dBV,
20 mV RMS
Maximum Input Level: 0 dBV,
1.0 V RMS
Preamp Low Gain Input:
(-6 dB Pad)
Impedance: High Z, 44 K ohms
all levels are increased by +6 dB
Effects Send:
Load Impedance: 47 K ohms
or greater
Nominal Output: -10 dBV,
300 mV RMS
Effects Return:
Impedance: Very high Z,
470 K ohm
Designed Level: -10 dBV,
300 mV RMS
Preamp Output:
Load Impedance: 47 K ohms
or greater
Nominal Output: +10 dBV,
3 V RMS
Remote Footswitch:
Special 3 button unit with LED
indicators (supplied)
System Hum & Noise @
Nominal Level:
(clean channel)
(20 Hz to 20 kHz unweighted)
Greater than 74 dB below rated
power (Special noise gate
circuitry for Ultra & Crunch)
Equalization:
(clean channel only)
Custom Low, Mid, & High
passive type EQ
Push Bright: +6 dB @ 2 kHz
Voicing: (Ultra and Crunch
channels only)
Active Bottom, Body, and
Edge EQ
Push Gain: Increases gain in
Ultra and Crunch channels