Peavey XR 400 - Safety and Operating Instructions; General Safety Precautions; Operating Instructions; Hearing Protection Warning

MONITOR
MON. AMP
TYPICAL OF 4 CHANNELS
GAIN
e Ei
MAIN AMP
MASTER
Eo
EFFECTS
£0
w m
oraemon []
TO MONITOR BUSS
GAIN i
| ame TO MAIN BUSS
TO EFFECTS BUSS
O
MAIN BUSS SUM
MONITOR
ttt
el
OD
MONITOR Buss
we
aw our EoD
erate
ron at
[venroncsr aa
EFFECTS OUT
oP
EFFECTS BUSS Ee te
` POWER AMP
= spka
OUT
1
vm
TO MAIN BUSS
mv
(i
REVERE
RETURNI
q
REV.
FOOTSWITCH
REVERB oniwe
REVERB UNIT
DANGER
TO MAIN MIX BUSS
EXPOSURE TO EXTREMELY HIGH NOISE LEVELS MAY CAUSE A PERMANENT HEARING LOSS INDIVIDUALS VARY CONSIDERABLY IN SUSCEPTIBILITY TO NOISE
SOME HEARING IF EXPOSED TO SUFFICIENTLY INTENSE NOISE TOR A SUFFICIENT TIME
INDUCED HEARING LOSS. BUT NEARLY EVERYONE WILL LOSI
[THE US GOVERNMENT'S OCCUPATIONAL SAFETY AND HEALTH ADMINISTRATION (OSHA) HAS SPECIFIED THE FOL
[DURATION PER DAY IN HOURS
‘OWING PERMISSIBLE NOISE LEVEL EXPOSURES
SOUND LEVEL ABA SLOW RESPONSE
io
we
0
ns
[ACCORDING TO OSHA, ANY EXPOSURE IN EXGESS OF THE ABOVE PERMISSIBLE LIMITS COULO RESULT IN SOME HEARING LOSS.
EAR PLUGS OF PROTECTORS IN THE EAR CANALS OR OVER THE EARS MUST BE WORN WHEN OPERATING THIS AMPLIFICATION SYSTEM IN ORDER TO PREVENT A
PERMANENT HEARING LOSS IF EXPOSURE IS IN EXCESS OF THE LIMITS AS SET FORTH ABOVE TO INSURE AGAINST POTENTIALLY DANGEROUS EXPOSURE TO HIGH
ESUND PRESSURE EVELS 1T S RECOMMENDED THAT ALL PERSONS EXPOSED TO EQUIPMENT CAPABLE OF PRODUCING HIGH SOUND PRESSURE LE
THIS AMPLIFICATION SYSTEM BE PROTECTED BY HEARING PROTECTORS WHILE THIS UNIT IS IN OPERATION.
TIO
TS SUCHAS
THIS AMPLIFIER HAS BEEN DESIGNED AND CONSTRUCTED TO PROVIDE ADEGUATS POWER RESERVE FOR PLAYING MODERN MUSIC WHICH MAY REQUIRE
BCGASIONAL PEAK POWER TO RANDLE OCCASIONAL PEAK POWER. ADEQUATE POWER “HEADROOM HAS BEEN DESIGNED INTO THIS SYSTEM. EXTENDED
OPERATION AT ASSOLUTE MAXIMUM POWER LEVELS IS NOT RECOMMENSED SINCE THIS COULD DAMAGE THE ASSOCIATED LOUDSPEAKER SYSTEM. PLEASE BE
ENARE THAT MAXIMUM POWER CAN B£ OBTAINED WITH VERY LOW SETTINGS OF THE GAIN CONTROLS IF THE INPUT SIGNAL I5 VERY STRONG
Read ali satety ane operating instructions betore
Using this product
All satety and operating instructions should be
(Obey ail cautions in tne operating instructions
Sng on me back of the uni!
AII operating instruetions should be followed:
“This product should not be used near water, ie. a
patr tun. sink, swimming poo), wet Baservent etc.
This produet snouie ve tocated so thatits position
dosa not intortero wiin ts proper vention. It
Should not bo places fat against a wall or placed
in a built-in enclosure that will impede tne low of
cooling air.
This product should not ba placed noar a source
Gl heat such asa stove. heater radiator or anothor
hes! producing ampir
EEI
8 Comec! only to a power supply of the type
marked on tre unit adjacent to the Dower supaty
cord
Never break olf the ground pin an the power
supply cord For more information on grounding
tune Yor our Iree booklet “Shock Hazard and
Grounding
Power supply cords shouid always be handled
carotuiy Never walk oF place equipment or
Bower supply cords. Periodically enost coras for
Guts or signs of stress, especially at tne plug anc
no point whore the cord exit 1na UMIT,
The power supply cora shouia ve unplugase
wnon tho unit e to bo unusod for long porloas oF
Metal paris can be cleanog with a damp rag. The
Vinyl covering used on some unita can be cleance
wth a damp ag, of anammonia based household
Cleaner # necessary
PEAVEY ELECTRONICS CORP. / 711 A Street / Meridian, MS 39301 / U.S.A.
13. Garo snouia bo takon so that objects do not tal!
and auias are not spilled into the unit Iouan
the ventilation holes or any other apanings
This unitshouls be checked by aqualtied service
technician "t
‘A. The power supply cord ar plug has been
damaged
B Anyihing has fallen or been spilled into the
c The unit aves not operate correctly
D. Theunitnae baen cropped or neenciosure
camaged
‘Tne user should not attempt to service this
eguipment An sorvico work shoul be done by è
‘avalies servico technician,
ue to ouretforts for constant improvement, specifications are subject to change without notice.
21682 Printed in USA. 10/83 #80322005