Need help?Do you have a question about the Peavey XRD 680 PLUS and is the answer not in the manual?
General| Type | Powered Mixer |
|---|---|
| Channels | 6 |
| Phantom Power | Yes |
| USB Interface | No |
| Power Output | 680 Watts |
| Outputs | Monitor |
| EQ | 3-band |
| Effects | Digital effects processor |
Indicates effects system clipping status. Blinking or fully illuminated.
Selects digital effect type and time from 128 available options.
Provides ±12 dB equalization at center frequencies for room tuning.
1/4" jack for main system mix signal, before graphic EQ.
1/4" jack for monitor mix signal to external monitor amp.
1/4" jack for EFX mix signal to external effects equipment.
1/4" input to internal graphic EQ, bypasses normal signal path.
1/4" jack providing access to internal graphic equalizer output.
1/4" jack for connecting a footswitch to activate/defeat digital effects.
Controls signal level at tape-out jacks.
Controls level of tape/aux signals sent to the main mix.
Assigns TAPE/AUX signal to the monitor mix.
Paralleled input for mono mixing of stereo tape deck outputs.
Jacks supplying signal to left/right inputs of a stereo tape deck.
Illuminates when AC power is supplied to the amp.
Selects amplifier power ON/OFF, including grounding options.
Adjusts ground position to minimize hum or popping noise.
Three-wire grounded mains cable for safety.
Protects the unit; must be replaced with the same type and value.
For connecting external speaker cabinets; min 4 ohms impedance.
Allows storage of mains cable for travel.
Details equivalent input noise, frequency response, distortion, input impedance, and EQ.
Details filter bandwidth, frequencies, Q, boost/cut, noise, distortion, and frequency response.
Covers gain, output levels, headroom, impedance, and noise.
Details reverb settings, frequency response, quantization, and SNR.
Covers input sensitivity, output power, THD, protection, and power requirements.
Covers product defects for one year, excluding covers, footswitches, etc.
Covers tubes and meters for ninety days from purchase date.
Outlines conditions that void warranties and limitations of liability.
Instructions for completing and mailing the warranty registration card.
Read all instructions, avoid water, ensure ventilation, proper connections.
Discusses OSHA permissible noise levels and hearing protection.
To Next Page
