※ If you need to plug and unplug the connector during charging, please turn off the charger before plugging and unplugging the cables.
※ When setting the starting voltage, please debug in this way, If the setting voltage is too low, the car battery power will be drained,
resulting in the car not being able to ignite and start normally.
Step 2: First check if cables correctly connect and then turn on the switch button.
Step 3: Check if the status of the car charger is normal and calibrate its voltage.
Normal state: The car charger doesn't work when the car is not started. The car charger starts working after the car is started.
After starting the car, if the car charger does not work, you need to lower the starting voltage.
If the car charger works even when the car does not start, the starting voltage needs to be increased.
Starting Voltage Range
12V~30V
12V~17V / 24V~30V
12.5V~17V / 25V~30V
13V~17V / 26V~30V
13.5V~17V / 27V~30V
14V~17V / 28V~30V
Gear Level
0
1
2
3
4
5
12V
support@pecron.com
To Next Page
Loading...