What to do if the water pressure switch is open on my PEERLESS Boiler?
If the water pressure switch on your PEERLESS Boiler is open, ensure the system pressure exceeds 10 psig. Also, check for leaks in the system piping. To check the switch operation, apply a jumper. Replace the switch if it's not functioning correctly.
How to fix a high limit exceeded error on a PEERLESS Gas?
If the high limit has been exceeded on your PEERLESS Boiler, first check the circulation pump operation. Then, ensure adequate flow through the boiler by checking the status menu, making sure there's less than a 50°F rise from the return thermistor to the supply thermistor. Finally, replace the switch if it's faulty.
What to do if the blocked vent pressure switch is open in my PEERLESS Gas?
If the blocked vent pressure switch is open on your PEERLESS Boiler, make sure that the vent is not blocked. Check the switch operation by applying a jumper. Replace the switch if it is not functioning properly.
Why is the combustion fan speed high on my PEERLESS Boiler?
If the combustion fan speed is too high on your PEERLESS Boiler, begin by checking the combustion air fan wiring. If the wiring is correct, consider replacing the combustion air fan. If problems persist, the control board may need replacement.
Why is the combustion fan speed low on my PEERLESS Gas Boiler?
If the combustion fan speed is low on your PEERLESS Boiler, first check the combustion air fan wiring. If the wiring is correct, consider replacing the combustion air fan. If problems persist, the control board may need replacement.
Critical warnings about fire and explosion risks if the manual is not followed.
Steps to follow if a gas leak is detected, emphasizing safety and contacting authorities.
Adherence to state, local, ASME, NFPA, and ANSI codes for boiler installation.
Follow local codes and the National Fuel Gas Code for all fuel piping.
How to calculate gas rates and size fuel lines using input rates and heating values.
Procedures for installing sediment traps, service valves, and maintaining regulator distance.
Steps for purging air from gas lines and checking supply pressure.
Illustrations of the gas valve assembly and instructions for adjusting the throttle screw.
Install per codes; boiler is direct vent; warning about positive pressure in the vent system.
Lists approved non-foam core pipe materials and warns against foam core for exhaust.
Details safety switches like low water, high temperature, and blocked vent limits.
Safety information and step-by-step guide for lighting and operating the appliance.
Detailed safety warnings and procedures for starting the boiler and setting the thermostat.
Explains how error codes are displayed and lists common errors with corrective actions.
Identifies fault codes displayed by the controller and provides troubleshooting guidance.
Detailed corrective actions for various boiler fault codes, including sensor and fan issues.
To Next Page
General