towards you while slipping the tray onto the
armrests. Push all the way in, as shown in the
figure.
10• The high chair tray can be adjusted to
three different positions. The third position
(marked with red notches)is not meant for
use with the tray; it is used for folding up
the tray.
• To extend the tray, pull the lever under it
towards you as you pull the tray out to the first
position. Repeat the operation to set the tray in
the second position.
• To remove the tray, pull the lever as you pull
the tray towards you.
11• The high chair comes with two trays. The child
can play on the lower tray and eat on the upper
one, which is easy to wash and can be kept
perfectly clean.
• To remove the meal tray, unhook it from the
lower tray by lifting as shown in the figure.
12• To put the tray back on the rear uprights of the
high chair, align it with the connections and
attach it, as shown in the figure.
• When the high chair is closed, the tray cannot
be attached to the rear uprights.
SAFETY BELT
13• Make sure that the shoulder strap is correctly
inserted, by pressing on it, as shown in figure A.
Fasten the lap belt as shown in figure B.
14• To unfasten the safety belt, press the sides of
the buckle (fig. A) while pulling the lap belt
outwards (fig. B).
15• The shoulder straps can be adjusted to two
different heights. Unfasten the safety belt from
behind the backrest by pushing the buckle
downwards (fig. A). Slip the safety belt out of
the sack (fig. B).
16• Next, slip the safety belt buckle through the
other opening in the backrest (fig. A), and
fasten the buckle to the peg, pulling the safety
belt until it clicks into place (fig. B).
7 HEIGHTS
The high chair adjusts to 7 different heights.
17• To lift the high chair, hold it under the tray and
pull upwards.
18• To lower the high chair, simultaneously press
the two side buttons, stopping at the desired
height.
These operations can be carried out with the
child in the high chair.
RECLINING HIGH CHAIR
19• The high chair reclines, and adjusts to four
different positions: for mealtime, playtime,
relaxing, or napping. To adjust it, lift the handle
behind the backrest and set the high chair to
the desired position. This operation can be
carried out with the child in the high chair.
CLOSING AND OPENING THE TRAY
20• To close the tray, pull it out to the third position
marked with the red notches shown by the
arrows in the figure.
21• Press button No. 1.
22• Press button No. 2, while lifting the tray
upwards until it clicks into place.
• To open the tray again, press button No. 2 and
lower the tray to the first or second position.
FOLDING UP THE HIGH CHAIR
• Before folding up the high chair:
- Close the tray.
- Return the backrest to the upright position.
- Lower the high chair to the lowest position.
- Close the footrest.
23• Unlock safety device A, by turning it in the
direction shown by the arrow, then press pedal
B.
24• Hold the high chair as shown in the figure
while unlocking the safety device and pressing
the pedal, and pull upwards.
• The high chair stands upright when it is closed.
REMOVING THE HIGH CHAIR COVER
25• To remove the high chair cover, remove the
safety belt from under the chair and the
backrest.
26• Lower the high chair completely, and unbutton
the cover from the sides of the backrest. Slip
the cover off the top of the high chair.
FOLDING THE HIGH CHAIR BACK UP INTO ITS
PACKING POSITION
• To fold the high chair back up into its “packing
position” (for transporting it or storing it in its
box):
- Remove the tray.
- Return the backrest to the upright position.
- Lower the high chair to the lowest position.
- Close the footrest.
27• A small screwdriver is necessary for this step.
Press the side button while slipping the
screwdriver into the slit. Push to the right.
28• Repeat the same operation, pushing the
screwdriver to the left and lowering the high
chair to the lowest position (the position in
which it cannot be used).
• Fold the high chair up and place it in its box.
accessory line
. 29• Centro Gioco: to attach the Centro Gioco, place
it as shown in the figure, and attach. Do not
attach the toy to the meal tray.
cleaning & maintenance
Your product requires only minimal
maintenance. Cleaning and maintenance
operations must be performed only by adults.
• Be sure to keep all moving parts clean,
lubricating them with light oil if necessary.
• Dry off metal parts to prevent rusting.
• Regularly clean the plastic parts with a damp
cloth. Do not use solvents or similar products.
To Next Page
Loading...
