- 37 -
4. Check under the seat that the adjuster
strap is not entangled with the vehicle
seatbelt.
5. Push the seat rmly into the vehicle seat
(1) and pull the vehicle belt (2) in order
to tighten the seat, eliminating any slack.
6. The picture shows the correct belt path
when the seat is attached to the vehicle using
a lap belt .
Once the installation is completed check that
the seat is properly levelled following the
section on page 28.
Verify that the child restraint is secure. A
secure child restraint will not move more than
2.5 cm (1 inch) near the UAS anchors.
Installing your child restraint in the vehicle - Rear Facing mode
4
5
1
6
To Next Page
Loading...
