20
Installing the booster seat in the vehicle
5. To release Viaggio
Shuttle 120 from the
vehicle seat, pull the
handle (1) and the seat
until the release buttons
on the side of the base are
fully revealed. In so doing,
the yellow release buttons
will be visible on the sides
of the base; pull the two
buttons (2) until you hear
the attachments click
open. At this point you can
remove the car seat.
6. To reposition the
connectors inside the base
(when not in use), pull the
lever once more (1) and
simultaneously push one
of the two connectors in (2)
until they disappear.
click
1
2
1
2
Installing the booster seat in the vehicle
How to attach the
booster seat on vehicle
seats not equipped with
latch anchor positions.
7. Place the Viaggio
Shuttle 120 car seat
on the vehicle seat in
the direction of travel,
leaving the connectors
inside the base.
To Next Page
Loading...
