IDENTIFICATION DATA
The appliance described in this manual is provided with a plate on the side reporting the
identification data of the same:
• Manufacturer Name
• Model of appliance
• Serial Number
• Power supply voltage
• Nominal current
STANDARD EQUIPMENT
For assembly and use, the EASYSTEAM line humidifiers are provided with:
N. 1 connection of 3/4 gas for water charging.
N. 1 connection with 40 mm external diameter for water discharge with fastening strip on ES series
models and with 25 mm external diameter for OEM series models.
N. 1 connection with 25 mm external diameter for the steam tube for models from 3 to 12 Kg/h and
with 40 mm external diameter for 24 and 48 Kg/h models, with relative fastening strap.
N. 1 use manual.
N. 1 test checklist reporting:
- humidifier model
- default configuration
- steam output at 100%
- electric power supply type
- absorbed power in KW
- nominal absorbed current
N. 1 ELECTRONICS KIT (only for OEM series models)
- Master HUM2 (electronic control board with PEGO EASYSTEAM software)
- NANO EasySTEAM (display for viewing state and settings)
- TOROID (current absorption sensor)
- CONNECTOR (movable connector for cylinder connection)
To Next Page
Loading...
Need help?
General
