Why are there spots on stainless steel from my Pelgrim GVW280L?
Certain foods like mustard, mayonnaise, lemon, vinegar, salt, and dressings can cause spots on stainless steel if left too long; rinse these off before using your Pelgrim dishwasher, or use the Rinse and hold program. Also, stainless steel can cause spots on silver if they touch during washing. Separate dishes made from different metals to prevent marks.
How to remove grease deposits in Pelgrim GVW280L?
If you're seeing grease deposits in your Pelgrim dishwasher, it might be due to using low-temperature programs for too long. Try selecting a program with Intensive mode, which uses a higher temperature to dissolve grease. Alternatively, run a self-cleaning program once or twice a month.
Why do the buttons not react on my Pelgrim Dishwasher?
If the buttons on your Pelgrim dishwasher aren't responding, wait a moment and try again, especially if you've just opened the door. Check if the child lock is activated. Remember, the buttons only work when the door is open. Also, ensure the buttons are clean; wipe them with a dry or slightly damp cloth.
Why are there spots on dishes from my Pelgrim Dishwasher?
If you notice spots or films on your dishes after washing in your Pelgrim dishwasher, first check the rinse aid dosage setting. If you're using all-in-one detergents with the TAB setting activated, try switching detergents or deactivating the TAB setting and adding salt and separate rinse aid. Also, ensure the salt compartment is full and the water softener setting is correct.
How to improve drying in my Pelgrim Dishwasher?
If your Pelgrim dishwasher isn't drying dishes adequately, ensure the Auto Open option is activated. Try fully loading the dishwasher, as a full load can improve drying. Check and replenish the rinse aid, or adjust the dosage. If using all-in-one detergents, consider switching brands or deactivating the TAB setting and using separate salt and rinse aid.
What to do if water remains in Pelgrim GVW280L?
If water remains in your Pelgrim dishwasher, start by cleaning the coarse and fine filters. Ensure the filters are correctly fitted and locked. Next, check for debris in the drainage pump, and make sure the drainage pump stop is in place. Inspect the drainage hose for kinks or blockages, ensuring the connection to the sink unit's water trap is clear and has an inner diameter of at least 14 mm.
Why does my Pelgrim GVW280L not start?
If your Pelgrim dishwasher isn't starting, make sure you press and hold the Start/Stop button until the display indicates the program has started. Ensure the door is properly closed. If you opened the dishwasher mid-cycle, simply close the door and wait for it to resume. Check the door lock, fuses/circuit breakers, and the plug connection. Also, verify the water tap is on and there are no overflows or leaks. If you hear a whirring sound that doesn't stop when the power is off, turn off the water tap, unplug the appliance, and contact service. Lastly, ensure the Delayed Start option isn't active; press and hold Start/Stop to cancel it if needed.
General| Noise level | 49 dB |
|---|---|
| Drying Class | A |
| Cleaning Class | A |
| Delay Start | Yes |
| Half Load Option | Yes |
| Water Softener | Yes |
To Next Page