Why did pairing fail on my Pelgrim Dishwasher?
If pairing failed on your Pelgrim dishwasher, check that the router is connected to the internet and that your smartphone/tablet is connected to your wireless network.
What to do if water remains in my Pelgrim GVWC330L/P06?
If water remains in your Pelgrim dishwasher, here are some things to check: * The filters might be clogged, so clean the coarse and fine filters. * Ensure the filters are fitted correctly. * There might be debris in the drainage pump. * Check that the yellow drainage pump stop is in place. * Inspect the drainage hose for kinks or sharp bends. * The drainage hose might be blocked. Disconnect it from the sink unit's water trap and ensure there's no debris and that the connection has an inner diameter of at least 14 mm.
Why won't my Pelgrim Dishwasher start?
If your Pelgrim dishwasher isn't starting, consider the following: * Ensure that the power button has been pressed; the display should start counting down. * Verify that the door is properly closed. * If you opened the dishwasher mid-cycle, close the door and wait for the program to resume. * Check that the door lock has clicked into place. * If the Delayed start option is selected, press and hold the button for three seconds to cancel it. * Make sure the plug is securely plugged into the wall socket. * Check if a fuse or circuit breaker has been tripped.
How to remove spots or films from dishes in my Pelgrim GVWC330L/P06 Dishwasher?
To address spots or films on dishes from your Pelgrim dishwasher: * Adjust the rinse aid dosage setting. * If using all-in-one detergent with the TAB setting activated, switch to separate detergents or deactivate the TAB setting and add salt and rinse aid. * Ensure the salt compartment is not empty and top up with salt if needed. * Verify that the water softener setting is correct.
How to get rid of bad odour in my Pelgrim GVWC330L/P06?
To eliminate bad odors in your Pelgrim dishwasher, clean around the seals and in corners with a washing-up brush and a low-foaming cleaner.
Why is the network symbol not showing on my Pelgrim GVWC330L/P06?
If the network symbol isn't appearing on your Pelgrim dishwasher's display, it means the dishwasher is not connected to your wireless network or the WiFi connection is deactivated. Connect the dishwasher to your wireless network or activate the WiFi connection.
What does error code F52 mean on my Pelgrim GVWC330L/P06 Dishwasher?
If your Pelgrim dishwasher displays error code F52, it indicates a water level fault. Clean the coarse and fine filters, and check that the outer filter on the inlet hose is not blocked.
How to remove spots left after washing in my Pelgrim Dishwasher?
If you notice spots left after washing in your Pelgrim dishwasher, especially from lipstick or tea, use a detergent with a bleaching agent.
Why is it important to run high temperature programs on my Pelgrim GVWC330L/P06 Dishwasher?
To maintain your Pelgrim dishwasher, run a program with a high temperature once or twice a month. Or run a self-cleaning program.
Why is the control panel on my Pelgrim GVWC330L/P06 Dishwasher not responding?
If the control panel on your Pelgrim dishwasher isn't responding, wait a moment before trying again if you've just opened the door. Ensure the door is open, as the control panel only works when open. Also, clean the control panel with a dry or slightly damp cloth to remove any dirt.
General| Brand | Pelgrim |
|---|---|
| Model | GVWC330L/P06 |
| Category | Dishwasher |
| Language | English |
To Next Page