What to do if Pairing failed on my Pelgrim Dishwasher?
If pairing failed on your Pelgrim dishwasher, check that the router is connected to the internet. Check that your smartphone/tablet is connected to your wireless network.
What to do if water remains in my Pelgrim GVWC270L/P06 Dishwasher?
If water remains in your Pelgrim dishwasher, start by cleaning the coarse and fine filters. Also, check that the filters are fitted correctly. Inspect the drainage pump for any debris and clean it if necessary. Ensure the yellow drainage pump stop is in place. Check the drainage hose for kinks or sharp bends. Finally, disconnect the drainage hose from the sink unit's water trap to check for blockages, ensuring the connection has an inner diameter of at least 14 mm.
Why won't my Pelgrim Dishwasher door close?
If you cannot close the door of your Pelgrim dishwasher, ensure that the baskets are correctly positioned horizontally and that dishes are not blocking the baskets from sliding properly into place. If the door lock does not click into place, open the door, press and hold Automatic door opening until the display counts down, wait until the countdown ends (60 seconds), then close the door and check that the door lock clicks into place.
What to do if the Pelgrim dishwasher's water softener is leaking salt?
Check that the salt compartment lid is properly tightened.
What to do if my Pelgrim GVWC270L/P06 Dishwasher shows F41 error?
Turn off the water tap and remove the plug from the wall socket.
How to fix spots or films on dishes in my Pelgrim dishwasher?
The rinse aid dosage setting may be incorrect, so adjust it accordingly. If the TAB setting is activated and you're using an all-in-one detergent with insufficient drying effect, switch to separate detergents or deactivate the TAB setting and add salt and rinse aid separately. Also, check if the salt compartment is empty and refill it if needed. Finally, ensure that the water softener setting is correct for your water hardness.
What to do if the water softener is leaking salt in my Pelgrim GVWC270L/P06?
Check that the salt compartment lid is properly tightened.
How to fix F10 error on Pelgrim Dishwasher?
To fix the F10 error on your Pelgrim dishwasher, unblock the drainage pump.
What causes spots left after washing in Pelgrim GVWC270L/P06?
Lipstick and tea can be difficult to wash off. Use a detergent with a bleaching agent.
Why does my Pelgrim GVWC270L/P06 have grease deposits?
Grease deposits in your Pelgrim dishwasher are often caused by prolonged use of low temperature programs. Select a program with a high temperature to dissolve grease on very dirty dishes, such as Intensive 70°.
General| Annual Water Consumption | 2520 l |
|---|---|
| Drying Class | A |
| Programs | 8 |
| Delay Start | Yes |
| Child Lock | Yes |
| Half Load Option | Yes |
To Next Page