G
G
USER GUIDE Fixion 2
29_133084_B
■ MAINTENANCE
ʚ CHARGER
This does not need any particular maintenance, but must be kept in a dry, ventilated, dust-free place, away from heat.
If the indicator light does not come on when charging:
- Disconnect the charger power connector.
- Check the mains supply.
- Reconnect. If the charger still does not work, return the complete equipment in its original packaging to a certied
repair service.
ʚ BUILT-IN BATTERY
ʚ MISC. MAINTENANCE
TAKE CARE:
NEVER TRY TO OPEN ONE OF THE COMPONENTS OTHER THAN THOSE SPECIFIED IN THIS
MANUAL.
- Do not leave the tying machine on the ground or exposed to the elements.
- At least once a year, or every 200,000 ties, return your tying machine in its original packaging to an approved repair
shop, for a proper overhaul to ensure a long life for your tool.
TAKE CARE:
DO NOT OIL THE CENTRAL PART WHERE THE CORD PASSES THROUGH, AS THIS COULD CAUSE
A MALFUNCTION.
TAKE CARE:
NEVER TRY TO OPEN ONE OF THE COMPONENTS OTHER THAN THOSE SPECIFIED IN THIS
MANUAL.
Spares references:
Fixion 2 wearing parts kit Ref. 140588
Go to your dealer to change this kit.
If your tying machine no longer works:
- Checking nothing is blocking the passage of the tie: Repeat the procedure in the “end of coil” section pages
12 - 13.
- Check the battery charge level.
- Press the tool on/off button.
- If the tying machine still does not work, return the complete equipment in its original packaging to a certied repair
service.
Make sure your tying machine continues to work properly by cleaning it often.
To do this:
- Keep the tie passage clean, by using compressed air through the front part and inside the machine. Avoid using
solvents such as trichlorethylene, white spirit, petrol, etc. If necessary, remove the upper guide (13) and hold the
trigger (19) for about 3 seconds to release the rod in its max upper position. Once cleaning is nished, press the
trigger (19) to return the tie hook (12) to its initial position, and replace the upper guide (13).
To Next Page
