PRUNING SHEARS AND 150 BATTERY VINION & PRUNION
26_116772-H
Degraded mode messages
Use
and alternately
• Stop the tool; the battery temperature is too high
1 long beep and 1 short beep • Stop the tool: current too high
1 long beep and 4 short beeps • Stop the tool; the tool temperature is too high
Charge
and alternately
• Charge interrupted: Battery temperature too low
and alternately
• Charge interrupted: Battery temperature too high
Fault messages
Use
and 1 beep every 2 minutes for 24 hours
• Voltage too low after 3 hours of non-use. Recharge
battery immediately
Charge
and alternating and continuous beep
• Battery problem
and alternately
• Charger problem
If your tool no longer works:
1. Turn off the battery (check that the LED is off).
2. Check the battery is charged, as shown on the gauge.
3. Check the lead is connected and the cable thumb-wheel tightened.
4. Turn on the battery (LED is on).
5. Press the trigger and the safety lock (depending on the tool).
6. If the tool does not work, return the complete equipment in its original packaging to a certified repair service.
Caution
Never attempt to open or repair the battery pack or the charger
8. TRANSPORT / STORAGE
8.1. STORAGE
• Store the pruning shears, battery unit and charger in their carry-case, away from heat, dust and damp, and check
the battery is properly turned off.
• Never store the battery at an ambient temperature of more than +45 °C.
• In order to conserve a long battery life and prevent deterioration, the battery must be charged when stored and
recharged every 24 months if it is not used.
• Never operate the switch while the shears are in storage.
• In the OFF-SEASON, you may have your pruning shears serviced by an authorised repairer. For more information,
consult an authorised distributor or contact PELLENC SAS.
• The battery must be stored in a dry place, at a steady temperature between 0 °C and +25°C. No combustible
object must be placed within 1.5 metres of the battery.
9. ACCESSORIES AND CONSUMABLES
• PRUNION blade kit (ref. 122991)
• PRUNION blade shaft kit (ref. 123762)
• PRUNION maintenance kit (ref. 122688): Refer to your dealer before changing this kit.
31
To Next Page
Loading...
