18
19
|
SETTING UP YOUR TREAD
SETTING UP YOUR TREAD CONTINUED
LEVELING
y If the Tread rocks or wobbles, stabilize it by adjusting the back feet.
y Use a 27mm wrench or an adjustable wrench to loosen the nut at the top of
each back leg.
y Turn one or both feet clockwise until all feet rest rmly on the ground.
y Tighten the locking nuts.
MOVING THE TREAD
y Make sure to power down and unplug the Tread before moving it.
y One person stands at front, holding the handrail.
y One person lifts from the back.
y Tilt the Tread forward.
y Slowly and carefully roll the Tread backwards or forwards.
For more information on transporting the Tread to a new location, contact
member support.
STORAGE
y Store the Tread in a dry, indoor area.
y Remove the Safety Key and store it in a separate location when the Tread is not in use.
y To reattach the Safety Key, t the magnet into the notch under the center button. Wrap
the cord around the cleat twice and place the clip on the magnet.
CAUTION: Do not attempt to move the Tread with fewer than two people.
PLUGGING IN AND POWERING ON
y Plug in the power cord.
y Switch the Tread on.
y Press the center button to wake the Tread.
POWERING OFF
y Press and hold the center button.
y Switch the Tread off.
ADJUSTING THE TOUCHSCREEN
y Hold the top and bottom of the screen and tilt back or forward.
y You should be able to look at the screen comfortably from the center of the deck.
To Next Page
Loading...
