Pelpro PP60 - User Dial Control; Filling the Hopper; Priming the Feed Tube

PP60 TROUBLE SHOOTING MANUAL
8-5-2013
3 FLASHES: AMBIENT PROBE ALARM
HOME
HOME
PAGE 7
LOCATE THE AMBIENT PROBE
CONNECTION ON THE CONTROL
BOARD
UNPLUG THE
PROBE, INSPECT
THE CONNEC-
TION & CHECK
ENTIRE WIRE FOR
DAMAGE
SYSTEM IS
REPAIRED
IS THE WIRE
PLUGGED
INTO THE
BOARD?
YES
NO
MAKE THE REPAIR
BY REPLACING THE
PROBE OR FIXING THE
CONNECTION.
DID THE ALARM
CODE GO AWAY?
PLUG THE PROBE
BACK INTO THE
CONTROL BOARD.
YES
NONO
YES
DID THE ALARM
CODE GO AWAY
AFTER PLUGGING
THE PROBE BACK
IN?
TECH TIP:
THE PROBE WILL SENSE TEMPERATURE IN THE ROOM. IF THE
UNIT IS CYCLING TOO MUCH, MOVE THE PROBE FARTHER AWAY
FROM THE STOVE.