What to do if my Pentair Water Pump motor will not run?
If the Pentair Water Pump motor won't run, it could be due to a blown fuse or a tripped circuit breaker. To resolve this, disconnect the power and replace the fuse or reset the circuit breaker.
How to improve water delivery to full capacity of Pentair Water Pump?
If your Pentair Water Pump isn't delivering water to its full capacity, consider these factors: if the water source is deeper than estimated, a deep well jet may be needed if the water being pumped is from a depth of more than 25’. If steel piping is used, corrosion or liming could cause excess friction; replace it with plastic pipe where possible, or use new steel pipe. Ensure the piping isn't too small by re-piping using the correct suction and discharge port sizes. It's also important to ensure the pump is adequately supplied with water, so add additional well points if needed.
What to do if my Pentair 123343 Water Pump runs but no water is delivered?
If your Pentair Water Pump runs but isn't delivering water, several issues could be the cause. If it is a new installation, it may not have picked up prime. Try re-priming it according to the instructions. Also, inspect all connections on the suction line with soapy water. Other solutions include replacing the foot valve, re-piping using the correct suction and discharge port sizes, checking all connections on the suction line and shaft seal with soapy water if the pump has lost prime, lowering the suction line further into the water and re-priming. If the receding water level in the well exceeds 25’, a deep well pump is needed. Also, try cleaning the impeller, replacing the foot valve, thawing pipes, raising the foot valve and/or strainer above the bottom of the water source, and cleaning...
Details for the portable utility and sprinkler pump model.
Important safety alerts and general precautions for pump operation and use.
Critical safety guidelines for electrical connections and pump operation.
Explains the terms, conditions, and duration of the product warranty.
Lists products with different warranty periods and general exclusion clauses.
Technical details including voltage, amperage, and discharge adapter size.
Essential checks and preparation before installing the pump.
Step-by-step instructions for preparing the pump for operation.
Guidance on drawing water from lakes, streams, and ponds.
Instructions for connecting suction and discharge lines and hoses.
Instructions for boosting city water pressure and lawn sprinkling.
Details on connecting the pump to power outlets and extension cords.
Information on motor lubrication and general pump maintenance.
Diagnosing and resolving problems with motor operation or overheating.
Troubleshooting steps when the pump fails to deliver water.
Identifying causes and solutions for low water output.
Visual guide showing all pump components and their assembly.
List of part numbers corresponding to the diagram for ordering.
General| Brand | Pentair |
|---|---|
| Model | 123343 |
| Category | Water Pump |
| Language | English |
To Next Page