What to do if my Pentair NOCCHI DP 130/6 supplies a limited amount of water?
If your Pentair Water Pump is only supplying a limited amount of water, consider the following: * The suction grid may be partially obstructed. Clean the grid. * There might be obstructions in the pipe. Remove any obstructions.
What to do if my Pentair NOCCHI DP 130/6 motor is running but not pumping water?
If your Pentair Water Pump isn't pumping water but the motor is running, it could be due to several reasons: * The suction grid might be obstructed. If so, clean the grid. * The check valve could be blocked. Clean or replace the valve. * There might be air in the impeller body. Perform several start-ups to remove all the air.
Why is my Pentair NOCCHI DP 130/6 having intermittent operation?
If your Pentair Water Pump is experiencing intermittent operation, here are a few potential causes and solutions: * Solid particles might be preventing the free rotation of the impeller. Remove any foreign particles. * The voltage might be out of range. Ensure you are supplying the pump in accordance with the nameplate data. * The fluid might be too dense. Dilute the pumped fluid.
How to troubleshoot a Pentair Water Pump that is not pumping water and the motor is not running?
If your Pentair Water Pump isn't pumping water and the motor isn't running, here are a few things to check: * Ensure the pump has electricity. * Verify that the plug is correctly inserted to provide voltage. * Check if the safety switch is enabled. Reset the safety switch. If it trips again, contact a specialized electrician. * The impeller might be blocked. Remove any obstructions from the impeller.
Identifies the specific pump models covered by the manual.
Official declarations of compliance with EU directives and standards.
Explains the meaning of hazard symbols for user and equipment safety.
Emphasizes the importance of reading the manual before pump installation.
Details permissible applications and types of fluids the pump can handle.
Outlines critical restrictions such as forbidden liquids and dry running.
Critical safety measures regarding electrical connections during pump installation.
Instructions for physical installation, including handle, pipe, and float switch setup.
Essential safety requirements for electrical connections, grounding, and circuit breakers.
Step-by-step guide and precautions for safely initiating pump operation.
Explanation of the built-in thermal protection switch for motor overload.
Information on general maintenance needs, such as cleaning hydraulics or replacing impellers.
A comprehensive table detailing common pump issues, their causes, and remedies.
A visual schematic showing the pump's dimensions and key reference points.
Outlines the scope of the legal warranty, including covered defects and claim procedures.
Specifies conditions that void the warranty and provides important user advice.
General| Power | 0.9 kW |
|---|---|
| Voltage | 230 V |
| Frequency | 50 Hz |
| Phase | Single-phase |
| Maximum head | 6 m |
| Outlet connection | 1.5 inch |
| Max Head | 6 m |
| Inlet/Outlet Size | 1.5 inch |
To Next Page