6
DORADO™ Automatic Pool Cleaner Installation and User’s Guide
Optional Installation (Continued)
6. Check Flow
With the main drain closed, and one end of the hose attached to the vac port
fitting installed in the dedicated vacuum line, insert the flow gauge into the
other end of the hose. Keep the hose and flow gauge underwater. Turn on the
pump. With the pump running, adjust the vacuum regulator (in your skimmer)
until the indicator on the flow gauge is between minimum and maximum flow
(Figure 18). Remove the flow gauge and proceed to step 7.
7. Connect Hose to the Cleaner’s Swivel Assembly
Connect the large hose cuff (Figure 19) of the leader hose to the swivel assembly on the Dorado™ Automatic
Pool Cleaner head. Push the cleaner into the pool and let it sink to the bottom (Figure 20).
8. Turn the pool pump on
After completing the installation, turn the pool pump on and allow it to run for a couple of minutes to ensure
that all air cycles out of the system.
Figure 18
Disc Indicator
Figure 20
Large hose cuff
of leader hose
designed to connect
to swivel assembly
(See “Assembling the
Hose” on Page 2)
Figure 19
To Next Page
Loading...
