4
DORADO™ Automatic Pool Cleaner Installation and User’s Guide
Standard Installation (Continued)
5. Check Flow
With the main drain closed, and one end of the hose attached to the regulator
installed in the skimmer, insert the flow gauge into the other end of the hose.
Keep the hose and flow gauge underwater. Turn on the pump. With the pump
running, adjust the vacuum regulator (in your skimmer) until the indicator on the
flow gauge is between minimum and maximum flow (Figure 11). Remove the
flow gauge and proceed to step 6.
6. Connect Hose to the Cleaner’s Swivel Assembly
Connect the large hose cuff (Figure 12) of the leader hose to the swivel assembly on the Dorado™ Automatic
Pool Cleaner head (Figure 12). Push the cleaner into the pool and let it sink to the bottom (Figure 13).
Figure 13
7. Turn the pool pump on
After completing the installation, turn the pool pump on and allow it to run for a couple of minutes to ensure that all
air cycles out of the system.
Figure 11
Disc Indicator
Large hose cuff
of leader hose
designed to connect
to swivel assembly
(See “Assembling the
Hose” on Page 2)
Figure 12
To Next Page
Loading...
