Need help?Do you have a question about the Pentair HAFFMANS i-DGM and is the answer not in the manual?
General| Category | Measuring Instruments |
|---|---|
| Model | i-DGM |
| Application | Dissolved gas measurement in beverages |
| Power Supply | 24 V DC |
| Protection Class | IP65 |
| Operating Temperature | 0 to 40 °C |
| Output Signal | 4-20 mA |
Describes the purpose and application of the DGM for measuring dissolved O2 and CO2 in drinks and O2 in gases.
Provides essential safety guidelines and warnings for using the instrument safely.
Explains how the O2 and CO2 measurements are performed using luminescence and Henry's law.
Details how the handle operates the inlet/outlet and initiates measurement.
Explains the optical luminescence principle used for oxygen measurement with LHO and WLO sensors.
Outlines the available measurement programs for the c-DGM and initial flushing procedure.
Guides on selecting one of the six measurement programs available on the c-DGM.
Step-by-step procedure to access and view stored measurement data from the logbook.
Detailed procedure for charging the instrument's battery pack, including safety warnings.
Recommends monthly calibration of the pressure sensor and outlines the initial steps.
Discusses the infrequent need for O2 sensor calibration and the warning for replacement.
A table listing common problems, their causes, and suggested solutions.
To Next Page
