What to do if LED does not light up when starting measurement on Pentair Measuring Instruments?
If the LED doesn't light up when you start a measurement, it could be due to a dead battery. Try replacing the battery. Also, verify that the battery is correctly positioned, paying attention to the positive (+ve) and negative (-ve) terminals.
Why is my Pentair Measuring Instruments plunger leaking?
A leaking plunger can be caused by damaged O-rings or an incorrectly set handle. To fix this, disassemble the plunger and either clean or replace any damaged O-rings. Also, make sure to adjust the handle to the correct position.
What to do if there is no electrolysis after starting the measurement with Pentair Measuring Instruments?
If there is no electrolysis after starting the measurement, the battery may be empty, so you should replace it. Also, the electrical unit with the LED could be faulty, in that case replace the electrical unit.
Why is the LED flashing on my Pentair Measuring Instruments?
If the LED is flashing, it means the battery is almost empty. Replace the battery to solve this issue.
How to fix a plunger that doesn't move freely in Pentair Measuring Instruments?
If the plunger doesn't move freely, it's likely due to a dirty plunger and/or O-rings. Disassemble and clean the plunger, or replace the damaged O-rings.
What to do if the pressure gauge does not give a reading on Pentair Measuring Instruments?
If the pressure gauge isn't giving a reading, it's likely faulty and needs to be replaced.
What to do if the thermometer does not give a reading on Pentair Measuring Instruments?
If the thermometer isn't giving a reading, it probably means the thermometer is faulty. Replace it.
Defines the specific purpose and application of the CO2 Gehaltemeter.
Provides essential instructions and explanations for the safe use of the CO2 Gehaltemeter.
Details critical safety precautions that must be strictly observed during the use of the instrument.
Explains the significance of attention, warning, and danger symbols used in the manual.
Guides the user on checking the delivery contents for completeness and damage after unpacking.
Provides instructions for correctly installing the 9V alkaline battery into the instrument.
Explains how to calibrate the pressure gauge using a Haffmans Gauge Calibration Device (GCD).
Details the daily procedure for rinsing the CO2 Gehaltemeter with cold water after measurements.
Outlines the weekly cleaning process, including warnings and recommended cleaning solutions.
Provides a chart listing common faults, their possible causes, and solutions for the CO2 Gehaltemeter.
Step-by-step instructions for removing and installing a new pressure gauge on the instrument.
Details the procedure for replacing the 9V battery when the LED flashes, ensuring no condensation.
Provides instructions for removing and installing a new thermometer in the instrument.
Outlines the process for replacing the main electrical unit (PCB) of the instrument.
General| Category | Measuring Instruments |
|---|---|
| Manufacturer | Pentair HAFFMANS |
| Accuracy CO2 | ±0.05 g/L |
| Resolution CO2 | 0.01 g/L |
| Accuracy Temperature | ±0.2 °C |
| Resolution Temperature | 0.1 °C |
| Power supply | 6 V DC (4 x 1.5 V AA batteries) |
| Application | Beverage Industry (Beer, Carbonated Soft Drinks, Sparkling Wine) |
| Weight | 1.5 kg |
| Accuracy | ±0.05 g/L CO2 |
| Response Time | 30 seconds |
| Operating Temperature | 0-40 °C |
To Next Page
