Pentair i-Link - System Commands;Command Format; SPA: Spa Control - Control;Query;Toggle Spa; PUMP: Pool Control - Control;Query;Toggle Pump (Pool)

IntelliTouch i-Link Protocol Interface Adapter User’s Guide
System Commands / Command Format
System commands differ in various ways. Some may be used to set a state, toggle
a state, or query a state. Others may be query only, or Set and Query but not
Toggle.
SPA: Spa Control - Control/Query/Toggle Spa
Request State:
Query: #SPA ?<cr>
Response: !00 SPA = x<cr> (RSPFMT = 0)
!00 x<cr> (RSPFMT = 1)
Where x is 1 or 0, and 1 indicates ON, 0 indicates OFF
Set State:
Command: #SPA = x<cr>
Where x is 1 or 0, and 1 indicates ON, 0 indicates OFF
Response: !00 SPA = x<cr> (RSPFMT = 0)
!00 x<cr> (RSPFMT = 1)
Where x is 1 or 0, and 1 indicates ON, 0 indicates OFF
Toggle State:
Toggle: #SPA <cr>
Response: !00 SPA = x<cr> (RSPFMT = 0)
!00 x<cr> (RSPFMT = 1)
Where x is 1 or 0, and 1 indicates ON, 0 indicates OFF
PUMP: Pool Control - Control/Query/Toggle Pump (pool)
Request State:
Query: #PUMP ?<cr>
Response: !00 PUMP = x<cr> (RSPFMT = 0)
!00 x<cr> (RSPFMT = 1)
Where x is 1 or 0, and 1 indicates ON, 0 indicates OFF
Set State:
Command: #PUMP = x<cr>
Where x is 1 or 0, and 1 indicates ON, 0 indicates OFF
Response: !00 PUMP = x<cr> (RSPFMT = 0)
!00 x<cr> (RSPFMT = 1)
Where x is 1 or 0, and 1 indicates ON, 0 indicates OFF
Toggle State:
Command: Toggle: #PUMP <cr>
Response: !00 PUMP = x<cr> (RSPFMT = 0)
!00 x<cr> (RSPFMT = 1)
Where x is 1 or 0, and 1 indicates ON, 0 indicates OFF
6