Pentair NOCCHI FCD20 PVM 5-5 F - Transducer Value and Menu Access Settings

23
GB
Line n.1 TRANSLATOR
Non modifiable description
Line n.2 VALUE MAXIMUM BAR XX
The maximum value of the pressure transducer must be entered. Normally in our standard groups a transducer 0-5V 0-10 bar is
used, therefore value 10 must be entered for this transducer.
N.1 line ACCESS MENU
Description non modifiable
N.2 line TOTAL XX
• YES: permits to access menus 8 - 9 - 10
• NO: disable access to menus 8 - 9 - 10
ENTE R
ENTE R
ENTE R
Menu 6 regulating of operational parameters is accessed to by pressing key (20).
Press key (20)
Press key (20)
for about 2” until the following message will be displayed: appears the menu
2. MENU FOR REGULATING OPERATIONAL AND CALIBRATION PARAMETERS
The access to this menu is direct from configuration menu 1, otherwise proceed as follows:
check that all drawings are closed or that the water distribution network is cut. Bring the main switch to position I (ON).
While the small bell gives out some beeps, press the key, until the following message will be displayed:
M
A
SET POINT
Bar 05.0
6a
TRANSDUCE R
VALUE MAX Bar 10
4
MENU ACCESS
TOTAL YES/NO
5
MANUAL FUNCTION
Bar 05.0
PROG MENU.
THRESHOLD
INVERTERS
6