Pentair ULTRATEMP 110 - Default Chapter; Table of Contents

i
ULTRATEMP
®
Heat Pump Installation and User’s Guide
CUSTOMER SERVICE / TECHNICAL SUPPORT
If you have questions about ordering Pentair Aquatic Systems, (“Pentair”) replacement parts, and pool products,
please use the following contact information:
Customer Service (8 A.M. to 4:30 P.M. — Eastern
and Pacific Times)
Phone: (800) 831-7133
Fax: (800) 284-4151
Web site
visit www.pentairpool.com or www.staritepool.com to
find information about Pentair products.
TABLE OF CONTENTS
Technical Support
Sanford, North Carolina (8 A.M. to 4:30 P.M. ET)
Phone: (919) 566-8000
Fax: (919) 566-8920
Moorpark, California (8 A.M. to 4:30 P.M. PT)
Phone: (805) 553-5000 (Ext. 5591)
Fax: (805) 553-5515
Important Warning and Safety Instructions .......
Menu Tree Quick Start Guide ..............................
Before Installing the Heat Pump .........................
Heat Pump Overview
Installation Requirements
General Installation Information
ii
iii
1
1
1
1
Operating the Heat Pump
....................................... 16
Swimming Pool Energy Saving Tips
16
Heat Pump Control Panel Overview
16
Operator Menu Tree Guide
17
Starting and Stopping the Heat Pump
18
Changing the Set Point - Pool and Spa
18
Heat, Cool, and Auto Modes
18
Water Pressure Switch Adjustment 6
Multiple Unit Installation 7
Heat Pump, Heater, Solar Combination 7
Multiple Heat Pump Connections 7
Electrical Connections and Wiring 9
Wiring Diagram – (Single Phase – 50/60 Hz) 10
Wiring Diagram – (Three Phase – 60 Hz) 11
Connecting to an Automation System .................. 12
Remote Operation 12
Relay Remote Controls 12
Connecting to IntelliTouch or EasyTouch via
Heat Pump Spade Terminals 13
Connecting to IntelliTouch or EasyTouch via
RS-485 Connector 14
Pin Configuration for Heat Pump Control
B
oard to IntelliTouch 15
Connecting IntelliTouch or EasyTouch to the
Heat Pump 15
Maintenance
............................................................ 23
Water Chemistry
23
Winterizing
23
Spring Start Up
23
Inspection and Service
23
Owner Inspection
23
Professional Maintenance and Service
24
Technical Information
............................................ 25
Electrical Supply - Voltage Requirements
25
Temperature Resistance Chart
25
Ambient/Water Flow Table for Professional
Maintenance and Service
26
Heat Pump Pressure Drop
26
Troubleshooting
..................................................... 27
Replacement Parts
................................................. 31
Illustrated Parts View
31
Parts List
32
P/N 474099 Rev. Q 6/29/17
For pool energy saving tips, refer to page 16, under “Operating the Heat Pump”. For technical data, voltage
requirements, or ambient/water flow information, refer to page 25 at the back of the manual.
General Features
1
Heat Pump Timer
18
Installation and Location .....................................
2
Relay Remote
18
Materials Needed for Installation
2
RS-485 Remote (Serial Cable)
18
Equipment Pad
2
AutoSet Operation
19
Drainage and Condensation, Roof Run Off,
Extend Operation
19
and Lawn Sprinklers
2
Timers and Delays
20
Heat Pump Dimensions
2
Control Panel Alarm Messages
20
Location and Clearances
3
Service Menu Tree Guide
21
Anchor Clamp Installation
3
Setting Temperature Scale
22
Water Connections and Plumbing
4
Set Water Temperature Offset
22
Automatic Flow Control Valve
4
Defrost Cycle
22
Water Connections to the Heat Pump
5
Run Time Counters
22
Drainage Connection to the Heat Pump
5
Locking the Control Panel
22