Pentair ULTRATEMP 110 - Menu Tree Quick Start Guide

iii
ULTRATEMP
®
Heat Pump Installation and User’s Guide
ULTRATEMP
®
MENU TREE QUICK START GUIDE
1. Push the ON/OFF button to turn the unit on, the green “ON” light should be lit.
2. Select either Pool or Spa mode. The default is Pool mode.
3. Adjust the temperature to the desired setting by pushing either the UP arrow or DOWN arrow.
4. Allow 5 minutes for compressor restart delay.
See pages 17-22 for details on the Operator and Service menu screens on the control panel.
*
**
**
***
****
†
THE NUMBER ONE (1) IS
DISPLAYED WHENTHE
ASSOCIATED INPUT/
OUTPUT IS ONAND ZERO
††
(0) IS DISPLAYED WHEN
INPUT/OUTPUT IS OFF.
* Menu appears only if Heat and Cool mode is enabled
at the factory.
** Menu appears only if AutoSet or Extend is enabled in the
Service menu.
*** Menu appears only if a delay is active.
**** Menu appears only if Defrost is enabled in the Service menu.
†
INPUTSTATUS
WF = WATER FLOWSWITCH
HP = HIGH REFRIGERANT PRESSURE SWITCH
LP- LOWREFRIGERANT PRESSURE SWITCH
PL- POOL REMOTE
SP - SPAREMOTE
†† OUTPUTSTATUS
FAN - FAN
COMP - COMPRESSOR
PMP - FILTER PUMP
REV - REVERSINGVALVE
OPERATOR
MENU TREE
POOL
IDLE/HEAT/COOL
SET= ACT=
SPA
IDLE/HEAT/COOL
SET= ACT=
HEAT / COOL / AUTO
SET TO - H/C/A
HEAT PUMP RUNTIME
REMAINING = NONE
REMOTE MODE
OFF/RELAY/RS-485
AUTOSET
HEAT/COOL/AUTO
OVERRIDE IS ON/OFF
EXTEND
HEAT/COOL/AUTO
OVERRIDE IS ON/OFF
RESTART / PUMP START /
SENSING WATER TEMP
DELAYS
SUCTION TEMP
ACTUAL =
ALARM STATUS
HEAT/COOL/AUTO MODE
POOL/SPA
SERVICE
MENU TREE
LANGUAGE - IDIOMA - LANGUE
ENGLISH / ESPANOL / FRANCAIS
SOFTWARE VERSION
REV.
INTELL ADDRESS
ADDRESS = 1-16
PUMP START TIME
TIME = 1 - 4 HRS
**
PUMP START DELAY
TIME = 0 - 5 MINS
TEMPERATURE SCALE
FAHRENHEIT / CELSIUS
WATER TEMP OFFSET
OFFSET = -2 TO +2
DEFROST
ENABLE / DISABLE
AUTOSET
ENABLE / DISABLE
EXTEND
ENABLE / DISABLE
WF HP LP PL SP
1 1 1 0 0
FAN COMP PMP REV
1 1 1 0
TEMP. RECORD
HOUR # °F
RUN TIMES/COUNTS
OR TOVIEW
PRESS POOL/SPA
TO EXIT SETUP