8
Turning the Power On
Sliding the power switch to the (ON) position will turn
on the power. The ready lamp will light up when the
flash is charged. Sliding it to the (OFF) position will turn
off the power.
Test Flash
Check that the ready lamp is lit, then press the test
button (TEST). The test flash will discharge.
Auto Power Off Function
When the flash unit is left unused for about 3 minutes
with the power switch set to the (ON) position, it
automatically turns off to save the power.
Quick Start Function
If the flash unit is mounted on autofocus cameras,
press the shutter release button half way to turn on the
power.
00_AF200FGZ.book Page 8 Tuesday, June 19, 2007 1:42 PM
To Next Page
Loading...
