Pentax Espio - Film Loading

2. FILM LOADING (Mate sura Itw power is off before inserting the film.)
1 Slide the back cover release lever down in
the direction of the arrow to open the back
cover as illustrated.
2 Place the film cartridge in the film chamber
by fitting its flat side on top of the rewind
shaft first and then slide the top end into
the camera.
3 Pull the film leader out far enough from the
cartridge to reach the take-up spool O-
Align the tip with the film leader end mark
@
Notes:
• Make sure not to touch the lens with your
fingers.
• Make sure the film is placed properly be¬
tween the guide rails 0 .
• If there is dirt on the film detection section
O, film cannot be wound properly.
CFIat YES!
8
X Slack NO!