Pentax Espio - Page 21

Rewinding a film in mid-’roll
If you wish to unload a film before exposing
all the frames, follow the procedures as fol¬
lows.
1 Turn the main switch ON and keep the
drive button depressed for more than 3
sec., the rewind mode will be set and the
{itO ) mark appears on the LCD panel. The
(•)mark will also blink on the LCD panel.
2 Depressing the shutter release button
while holding the drive button down starts
the rewinding. When the roll of film is re¬
wound to its end, the motor stops and the
(0) blinks indicating that the back cover
may be opened safely.
17