Pentax IQZoom 80-E - LCD Display and Red-Eye Phenomenon

Symptoms
Causes and Remedies
4, The flash discharges, though it is
not dark.
• Daylight sync mode has been set. See page 21.
5. The [H ] or [ u ] mark is dis¬
played on the LCD panel
• If either mark disappears when the zoom lever is moved,
the camera is ready for use. The camera may be defective
if either mark appears often.
If the camera is placed in a condition where static electricity may be discharged on or near the
camera, the LCD display may go blank. If this happens, press the main switch again, or reset the
camera by removing the battery and reinserting it again. The camera will resume normal opera¬
tions and may be used in its usual ways.
Flash effective ranges other than ISO 100, 200 or 400 (Nega-color film used)
ISO
Lens
25
50
800
1600
--—
38mm ( M4 )
0.6-1.9m
(2.0-6.2ft)
0.6-2.7m
(2.0-8.9ft)
0.8'-11.0m
(2.6'-36.1ft)
1.2'-15.5m
(3.9’-51.0ft)
80mm ( ♦ )
0.6-1.0m
(2.0-3.3ft)
0.6-1.4m
(2.0-4.6ft)
0.6-5.5m
(2.0-18.0ft)
0.6-7.8m
(2.0-25.6ft)
* With high speed film, overexposure may occur at close range due to the film’s high speed.