•
.~----··--··
4 Press
the
shutter
release
button
fully.
Set the focus mode to MF when the shutter cannot be released.
The screen to select the measuring range
is
displayed.
5 Use
the
rear
e-dial
("#~.:-)
to
select
the entire screen or spot area for
the measuring range.
D
o
OK
6
When
a
spot
area
is
selected,
use
the
four-way
controller
{
..
T
,....
...,.
) to move the frame to the position you want to
measure.
II[§)
J Press
the
OK
button.
8
The white balance is measured, and the screen that was displayed
in
Step 3 appears again.
Adjust the white balance as necessary.
The message [The operation could not be completed correctly] appears
when measuring is unsuccessful. Press the
OK button to remeasure the
white balance.
Press the OK button twice.
The camera is ready to take a picture.
tr~;~o
• If a picture is extremely overexposed or underexposed, the white balance
may not be adjusted.
In
this case, adjust exposure to the correct amount level
before adjusting the white balance.
• When the mode dial is set to
~!!
(Movie), the white balance cannot be
measured. Adjust the white balance
in
any exposure mode other than
~!!
before recording a movie.
To Next Page
Loading...
