Pentax Optio P80 - Using the Power Saving Function

199
7
Settings
You can save battery power by setting the display to dim automatically
when no operation is performed for a fixed time. After the power saving
function has been activated, the display returns to the ordinary
brightness if any button is pressed.
1 Press the 3 button in Q mode.
The [W Setting] menu appears.
When you press the 3 button in A mode, press the four-way
controller (5) once.
2 Use the four-way controller (23) to select [Power
Saving].
3 Press the four-way controller (5).
A pull-down menu appears.
4 Use the four-way controller (23)
to select the time until the camera
enters power saving mode.
Choose from [2min.], [1min.], [30sec.],
[15sec.], [5sec.] or [Off].
5 Press the 4 button.
The setting is saved.
Using the Power Saving Function
• Power Saving does not function in the following situations:
- While taking pictures in j (Continuous Shooting) mode
- In the playback mode
- While recording a movie
- While the camera is connected to a computer
- When using the AC adapter
- While a menu is being displayed
• When no operation is performed after the camera is turned on, Power
Saving is activated only after 15 seconds elapse even if [5sec.] is set.
Setting
Power Saving
Auto Power Off
Video Out
Brightness Level
2/3
MENU
Cancel
C a n c e l
Cancel
OK
OK
OK
OK
2min.
Off
5sec.
30sec.
1min.
15sec.
Delete All
Reset