114
5
Function Reference
4
Use the four-way controller (3)
to select [K (Manual)].
5
Press the four-way controller
(5).
The message screen appears.
6
Fully display a white or gray sheet of paper in the
viewfinder under the light to adjust white balance.
7
Press the shutter release button fully.
[OK] appears on the LCD monitor when setting is successful.
[NG] appears on the LCD monitor if setting is not successful.
8
Press the 4 button.
• No image is recorded when the shutter release button is pressed to adjust
the white balance.
• Press the { button again when setting is unsuccessful to set again.
• You can set the range to measure white balance when setting manually.
White balance is measured using the entire screen using multi-segment
metering (p.130) if [Entire screen] is selected for [Man. WB Measurement] in
[A Custom] menu (p.101). White Balance is only adjusted in the spot
metering area (p.131) if [Spot Metering Area] is selected.
OK
OK
To Next Page
Loading...
