SSID
This setting specifies the Router SSID that Wi-Fi clients will see when
scanning.
Schedule
Click the drop-down menu to choose predefined schedules as your starting
point. Please note that upon selection, previous changes on the schedule
map will be deleted.
VLAN
Some service providers require the router to enable VLAN tagging for
Internet traffic. If it is required by your service provider, you can enable this
field and enter the VLAN ID that the provider requires.
Broadcast
SSID
This setting specifies whether or not Wi-Fi clients can scan the SSID of this
wireless network. Broadcast SSID is enabled by default.
Data Rate
Select Auto to allow your access point to set the data rate automatically, or
select Fixed and choose a rate from the drop-down menu. Click the MCS
Index link to display a reference table containing MCS and matching HT20
and HT40 values.
Multicast
Filter
This setting enables the filtering of multicast network traffic to the wireless
SSID.
Multicast
Rate
This setting specifies the transmit rate to be used for sending multicast
network traffic.
IGMP
Snooping
To allow your access point to convert multicast traffic to unicast traffic for
associated clients, select this option.
Layer 2
Isolation
Layer 2 refers to the second layer in the ISO Open System Interconnect
model.
When this option is enabled, it will block communication between Wi-Fi
clients within the same VLAN, SSID or subnet, as a security measure that
best suits a company Guest/Visitor Wi-Fi access scenario.
Do refer to this link (https://forum.peplink.com/t/lan-isolation-with-
balance30-and-ap-one-ac-mini-help-needed/3914/3) for visual illustration of
the feature. By default, the setting is disabled.
Maximum
number of
Clients
Enter the maximum number of clients that can simultaneously connect to
your SSID, or enter 0 to allow unlimited Wi-Fi clients.
To Next Page
Loading...
