Outbound
Mappings
This setting specifies the WAN IP addresses that should be used when an IP
connection is made from a LAN host to the Internet. Each LAN host in an IP
range or IP network will be evenly mapped to one of each selected WAN’s IP
addresses (for better IP address utilization) in a persistent manner (for better
application compatibility).
Note that if you do not want to use a specific WAN for outgoing accesses, you
should still choose default here, then customize the outbound access rule in
the
Outbound Policy
section. Also note that WAN connections in drop-in
mode or IP forwarding mode are not shown here.
Click
Save
to save the settings when configuration has been completed.
Important Note
Inbound firewall rules override the
Inbound Mappings
settings.
Ch. 12 QoS
User Group
(https://manual.peplink.com/documentation/pepwave-surf-soho-user-
manual/qos/user-group/)
Bandwidth Control
(https://manual.peplink.com/documentation/pepwave-surf-soho-user-
manual/qos/bandwidth-control/)
Application Queue
(https://manual.peplink.com/documentation/pepwave-surf-soho-user-
manual/qos/application-queue/)
Application Prioritization
(https://manual.peplink.com/documentation/pepwave-surf-soho-user-
manual/qos/application-prioritization/)
Prioritization for Custom Applications
(https://manual.peplink.com/documentation/pepwave-
surf-soho-user-manual/qos/prioritization-for-custom-applications%ef%bf%bc/)
DSL/Cable Optimization
(https://manual.peplink.com/documentation/pepwave-surf-soho-user-
manual/qos/dsl-cable-optimization%ef%bf%bc/)
PepVPN Traffic Optimization
(https://manual.peplink.com/documentation/pepwave-surf-soho-
user-manual/qos/pepvpn-traffic-optimization%ef%bf%bc/)
To Next Page
Loading...
