2
IMPORTANT SAFETY INFORMATION
WARNING!
READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS AND
WARNINGS BEFORE OPERATING THIS TOOL. FAILURE TO DO
SO MAY RESULT IN PERSONAL INJURY AND/OR PROPERTY
DAMAGE AND WILL VOID WARRANTY.
WARNING!
Oil tool before each use. 4 to 5 drops of a good grade Air Tool Oil placed in
the air inlet is sufficient. Use proper air pressure and CFM rating listed for
this tool.
1. Keep work area clean. Cluttered areas invite injuries.
2. Observe work area conditions. Do not use machines or power tools in damp
or wet locations. Don’t expose to rain. Keep work area well lighted. Do not
use electrically powered tools in the presence of flammable gases or liquids.
Do not bring combustible materials near the tools.
3. Keep children away. Children must never be allowed in the work area. Do not
let them handle machines, tools or extension cords.
4. Store idle equipment. When not in use, tools must be stored in a dry location
to inhibit rust. Always lock up tools and keep out of reach of children and
other untrained persons. Switch off all unused electrical tools when stored.
Tools are dangerous in the hands of untrained users.
5. Wear safety glasses. Always wear approved eye protection when using tools.
If raising dust, wear a suitable mask.
6. Work Safe. Keep proper footing and balance at all times. Do not reach over
or across running machines, hoses, etc.
7. Be sure air is in OFF position when connecting tool to air supply.
8. Be sure to disconnect tool from air supply before changing accessories,
performing service on tool and when not in use.
9. Use only those accessories that are designed for use with air tools. For
example, with impact wrenches do not use ordinary sockets. Use impact
sockets for all air impact wrench tools.
10. Follow air source manufacturers directions for connection of regulators,
filters, and other accessories to air source. Do not install quick couplers di-
rectly on tool as they put unnecessary strain on the air inlet threads possibly
causing them to wear out prematurely. Instead, install them on a short length
of air hose attached to the tool.
11.
Stay alert. Watch what you are doing, us common sense. Be sure all person-
nel are clear of sandblaster spray. Do not operate any tool when you are tired.
12. Take care of your tool. Keep the tool clean for better and safer work. Follow
the maintenance instructions and the notices. Regularly inspect all parts.
Repairs should only be carried out by a qualified technician. Use only original
PERFORMANCE TOOL® replacement parts.
13. Check for damaged parts. Before using any tool, any part that appears dam-
aged should be carefully checked to determine that it will operate properly