EasyManuals Logo

Performance Tool M573DB User Manual

Performance Tool M573DB
6 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
2
SPECIFICATIONS
Specifications are subject to change without notice
IMPORTANT SAFETY INFORMATION
WARNING!
READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS AND WARNINGS
BEFORE OPERATING THIS TOOL. FAILURE TO DO SO MAY RESULT IN
PERSONAL INJURY AND/OR PROPERTY DAMAGE AND WILL VOID WARRANTY.
1. Use only paper sanding disks with the proper adhesive. Read, under stand
and follow all adhesive manufacturers’ directions. DO NOT USE CLOTH
BACKED SANDING DISKS WITH THIS TOOL.
2. Make sure sanding pad RPM rating matches Free Speed rating of this tool.
3. Wear a dust mask while operating this tool. Read, follow and understand
manufacturers instructions on paint, primer, paint preps, glazing, body filler,
etc. for additional respirator and ventilating requirements.
Warning! Some dust created by power sanding, sawing, grinding, drilling,
and other construction activities, contain chemicals known [to the State of
California] to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are: Lead from lead-based paints, Crystal-
line silica from bricks and cement or other masonry products, Arsenic and
chromium from chemically treated lumber.
Your risk from these exposures varies, depending on how often you do this
type of work. To reduce your exposure to these chemicals: work in a well
ventilated area, and work with approved safety equipment, such as those
dust masks that are specially designed to filter out microscopic particles.
4. Always use approved eye and ear protection when using air powered tools.
If raising dust/debris, wear a suitable mask. Do not wear loose clothing or
jewelry.
5. Always operate tool a safe distance from yourself and others in the work
area. Keep footing and balance at all times.
6.
Make sure work piece is secure to allow safe operation of the tool with both hands.
Do not hold the work piece in your hand, lap or against any part of your body.
Pad Size (IN)..........................................................................5
Sanding Surface (SQ.IN)..............................................50-200
Spindle/Thread Size...............................................5/16 in.-24
Max air pressure (PSI).........................................................90
Avg CFM ............................................................................4.2
Free Speed (RPM)........................................................18,000
Air Inlet (NPT).................................................................1/4 in.
Hose Size.......................................................................3/8 in.
Weight (LBS).......................................................................2.2
Warning!
Oil tool before each use. 4 to 5 drops of a good grade Air Tool Oil placed in the
air inlet is sufficient. Use proper air pressure and CFM rating listed for this tool.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Performance Tool M573DB and is the answer not in the manual?

Performance Tool M573DB Specifications

General IconGeneral
BrandPerformance Tool
ModelM573DB
CategoryNail Gun
LanguageEnglish

Related product manuals