3
IMPORTANT SAFETY INFORMATION
OPERATION
1. Regulate pad speed with air regulator knob.
2. Start the sander off the sanding surface. Set the sander on the surface gently and
evenly and start the work. Let the sander do the work. The weight of the sander
will provide efficient sanding. Applying pressure to the sander will only slow
the speed of the pad and reduce sanding efficiency. This will also overload the
motor and cause premature wear of the tool and void the warranty.
3. Work the sander back and forth in a wide, overlapping motion. Lift the sander off
the surface before releasing the trigger.
4. Start with a paper grit coarse enough to remove high spots and rough areas.
Continue using progressively finer grit to attain desired finish.
7. Make sure trigger is in the “off” position before connecting or disconnecting
the tool from air source. Disconnect tool from air source before changing
accessories, performing service and when not in use.
8. Follow air source manufacturer’s directions for connection of regulators,
filters and other accessories to air source. Do not install quick couplers
directly at tool air inlet. This causes inlet failure due to excess weight and
vibration. Use a whip hose between tool and quick couplers.
9. DO NOT OVERLOAD! Do not force tool. Match tool capacity to work load
requirement. Use tool within its rated capacity and only for its designated
purpose. Overloading air tools will cause premature wear and/or permanent
damage of internal and external drive parts and will void warranty.
10. Inspect hoses and fittings for wear and damage prior to using tool. Do not
carry or drag tool by the air hose. Keep air hose free from obstruction, twist-
ing and binding.
WARNING: This product and its packaging contain a chemical known to the
State of California to cause cancer, birth defects, or other reproductive harm.
WARNING: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur. It
must be understood by the operator that common sense and caution are factors
which cannot be built into this product, but must be supplied by the operator.
Read and understand all of the instructions provided in the instruction manual of
this product, as well as, any other tool (s) used with this product.
Air Regulator
Air Inlet
Trigger
Back Pad
To Next Page
Loading...
Need help?
General
