EasyManua.ls Logo

Performance Tool M574DB User Manual

Performance Tool M574DB
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
WARNING!
READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS AND WARNINGS BEFORE
OPERATING THIS TOOL. FAILURE TO DO SO MAY RESULT IN PERSONAL INJURY
AND/OR PROPERTY DAMAGE AND WILL VOID WARRANTY.
Some dust created by power sanding contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. An example of
this type of chemical is lead from lead based paints. Your risk from these exposures varies, depending on how often you do this type of work. To reduce your expo-
sure: work in a well ventilated area and work with approved safety equipment, such as dusk masks that are specially designed to lter out microscopic particles.
P.O. Box 88259 Tukwila, WA 98138 • 1-800-497-0552 • www.wilmarcorp.com • Made in China • © Copyright 2010
Dual Piston Straight Line Sander
OWNER’S MANUAL
Stock Number M574DB
SPECIFICATIONS:
Pad size (IN.) ..........................................2.75 x 16.75
Air pressure (P.S.I.) .............................................90
Average air consumption (C.F.M.) ...................................5
Free speed (R.P.M.) .......................................... 2,500
Air inlet (N.P.T.)................................................ 1/4
Hose size (I.D.)..............................................3/8 in.
Length (IN.).................................................. 16.1
Weight (LBS) ................................................ 5.64
Specifications are subject to change without notice.
Question and Answer IconNeed help?

Do you have a question about the Performance Tool M574DB and is the answer not in the manual?

Performance Tool M574DB Specifications

General IconGeneral
BrandPerformance Tool
ModelM574DB
CategorySander
LanguageEnglish

Summary

Important Safety Information

Personal Protective Equipment and Operation

Wear appropriate PPE, maintain a firm grip, proper positioning, and keep fingers away from the trigger until ready.

Assembly and Installation

Connect Air Supply

Prepare and connect the 1/4" quick-disconnect coupler to the tool's air inlet using thread seal tape.

Operation

Operating Procedure

Operate the sander evenly on the workpiece, moving slowly and lifting off before stopping.

Lubrication and Maintenance

Pre-Use Lubrication

Apply 4 to 5 drops of air tool oil into the air inlet before each use.

Troubleshooting

Insufficient Power Issues

Addresses causes like dirty air passages, low air supply, air leaks, or worn parts.

Limited Warranty

Related product manuals