EasyManuals Logo

Performance Tool W2012 User Manual

Performance Tool W2012
7 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
WARNING! To prevent serious injury from accidental operation: Make sure that the trigger
is in the off position, unplug the tool from its electrical outlet, and allow it to cool completely
before performing any procedure in this section.
WARNING!
To prevent serious injury from tool failure: Do not use damaged equipment
if abnormal noise or vibration occurs, have the problem corrected before further use.
MAINTENANCE
1. Before each use, inspect the general
condition of the tool.
Check for:
Loose hardware
Misalignment or binding of
Moving parts
Damaged cord/electrical wiring
Cracked or broken parts
Any other condition that may
affect its safe operation.
2. After use, heat up the Soldering Tip again
and apply a small amount of rosin-core solder
to coat the tip. Wipe off with a rag. This will
leave the tip clean and ready for use.
3. If the Soldering Tip cracks or becomes
eroded, it needs to be replaced:
a. Using Wrench, loosen the Soldering Tip
Nuts by turning counterclockwise.
b. Pull the old Soldering Tip out of the
Transformer Assembly mounting posts.
c. Slide the ends of the new Soldering
Tip into the mounting posts of the
Transformer Assembly.
d. Carefully tighten the Nuts over the
mounting posts by turning clockwise.
Make sure that the Nuts fit squarely
over threads or damage will occur to
the mounting post threads. Do not
overtighten.
4. To replace the Light Bulb:
a. Remove the Light Bulb Lens from the
front of the Soldering Gun.
b. Pull out the burnt Light Bulb and
replace with a new one of the same
voltage andtype. See Specifications on
Page 3.
c. Replace the Light Bulb Lens.
5.
WARNING! If the supply cord of this power
tool is damaged, it must be replaced only
by a qualified service
technician.
6

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Performance Tool W2012 and is the answer not in the manual?

Performance Tool W2012 Specifications

General IconGeneral
BrandPerformance Tool
ModelW2012
CategorySoldering Gun
LanguageEnglish