3
1. Refer to your vehicle owner's manual for proper jacking procedures. Lift only on areas
of the vehicle as specified by vehicle manufacturer.
2. Position stands under vehicle at points specified by vehicle manufacturer as proper load
support points.
3. To adjust stands: Hold control lever
up while lifting saddle shaft to
desired height. Push control lever
down to lock pawl into teeth located
in center column. MAKE SURE
PAWL IS FULLY ENGAGED
INTO TEETH.
4. Carefully lower load onto stands.
Saddle
Pawl
Center
Column
Control
Lever
1. Visual inspection shall be made before each use of the stands, checking for cracks,
cracked welds and missing and/or damaged parts. Any stand that appears to be
damaged in any way shall be removed from service immediately.
2.
BECAUSE OF THE POTENTIAL HAZARDS ASSOCIATED WITH THE MISUSE OF
EQUIPMENT OF THIS TYPE, NO MODIFICATIONS SHALL BE MADE TO THE PRODUCT.
MAINTENANCE
UNPACKING/INSPECTION
After opening the carton, unpack your new product and related parts & accessories.
Please inspect it carefully for any damage that may have occurred during transit. Please
check it against the photograph on carton. If any parts are missing, please call customer
service at 1-800-426-1262 between 6 a.m. and 5 p.m. Pacific time.
WARNING: DO NOT operate this product if damaged during shipment, handling or
misuse. Do not operate the product until the parts have been replaced or the fault rectified.
Failure to do so may result in serious personal injury or property damage. All damaged
parts must be repaired or replaced as needed prior to operating this product. Check to see
that all nuts, bolts and fittings are secure before putting this product into service. If you
have any questions, or require assistance with damaged or missing parts, please contact
our factory customer service department at: 1-800-426-1262.
Please have the serial number, model number, and date of purchase available for
reference when calling.
OPERATION
To Next Page
Loading...
Need help?
General
