CARE & MAINTENANCE
1. Unplug the power cord from main socket before any installation, adjustment, repair,
cleaning or maintenance.
2. Replacement of carbon brushes. Used (shorter than 5mm), burnt or broken motor
carbon brushes should be immediately replaced. Both carbon brushes should always be
replaced at the same time.
• Loosen and remove the carbon brush plugs by unscrewing with a slotted screwdriver (7).
• Take out used carbon brushes and remove any carbon dust using compressed air.
• Insert new carbon brushes. Carbon brushes should slide smoothly into brush holders.
• Fasten the carbon brush plugs (7).
When the carbon brushes are removed, the device should be switched on for
approximately 1-2 minutes, so that carbon brushes can adapt to the motor. Carbon
brushes should be replaced only by a qualified person using identical replacement parts.
CLEANING
• It is recommended that you clean the device after each use.
• If possible, the motor housing should be always kept free from dust and debris.
• Wipe the device with a clean cloth or blow it with low pressure compressed air.
• Do not use water or chemical cleaning agents for cleaning.
• Be careful to prevent water from penetrating the device.
MAINTENANCE AND STORAGE
• Make sure the screws are properly tightened to be able to work safely. Use only original
accessories and original spare parts.
• If the device is not used, it should be stored in a dry place, away from children.
• In case of excessive sparking at the motor, have the condition of motor brushes
checked by skilled personnel.
• If the power cord is damaged, replace it with another one which has the same
characteristics. Entrust this operation to a qualified technician or a repair shop.
• All defects should be repaired by service workshop authorized by the manufacturer.
ENVIRONMENT PROTECTION
Expended electrical equipment can contain substances or materials that are hazardous
and pose a potential risk for environment and human health. Do not dispose of electrically
powered products with household waste. They should be processed in appropriate
facilities. Obtain information on proper waste management from your seller or local
authorities.
7
To Next Page
Loading...
Need help?
General
