10
CARE & MAINTENANCE
TROUBLESHOOTING
WARNING
Always turn power switch to
"OFF" position and unplug power cord
from electrical outlet before attempting
cleaning or maintenance.
NOTICE
This power tool is lubricated
before it leaves the factory. This lubrica-
tion should last for the life of the tool. No
further lubrication is required.
Make sure that the ventilation openings are kept
clean and free of foreign matter.
Use a mild soap and damp cloth to clean outside
of tool.
Do not use other cleaning agents, turpentine,
gasoline, lacquer thinner, paint thinner, or other
solvents that may contain chemicals which are
harmful to plastics and other insulating materials.
Never immerse tool in a liquid or allow a liquid to
enter inside the tool.
Never open the heat gun. Do not attempt to
repair the heat gun yourself, doing so will void
your warranty.
Problem Probable Cause Solution
Will not turn on. 1. Power switch set at
"OFF"
2. No Power at outlet
3. Cord not connected
1. Turn Power Switch to
“l” or “ll”.
2. Check power at outlet.
3. Check that cord is
plugged in.
Unsatisfactory results 1. Improper heat
settings.
1. Adjust heat settings
for correct application.