What to do if my Performax Saw blade binds and vibrates?
If your Performax Saw blade binds, jams, burns wood, or the saw vibrates, several factors could be at play. It may be due to a dull, warped, or damaged blade, or the use of an improper blade. Replace or sharpen the blade as needed. Also, ensure the arbor bolt is tightened. Review the OPERATION section to ensure proper usage.
Why won't my Performax 240-3688 motor start?
If your Performax Saw motor isn't starting, the issue could stem from a blown fuse or a worn brush. Check the time delay fuse or circuit breaker. If the brushes are worn, replace them. Refer to the MAINTENANCE section for guidance.
How to fix an inaccurate cut angle on my Performax 240-3688 Saw?
An inaccurate cut angle on your Performax Saw can occur if the miter table is unlocked. Tighten the miter table using the miter locking knob. Also, too much sawdust under the table can cause this issue. Vacuum or blow out the dust, and remember to wear eye protection.
What to do if the brake on my Performax 240-3688 Saw doesn't stop the blade?
If the brake on your Performax Saw fails to stop the blade within 10 seconds, several potential causes exist. The motor brushes might be sticking, so inspect, clean, or replace them, referring to the MAINTENANCE section. The motor brake could be overheated due to using a defective or wrong-sized blade, or rapid ON/OFF cycling, so use a recommended blade. Finally, a loose arbor bolt could be the culprit, so retighten it.
Why is the laser line on my Performax 240-3688 hard to see?
If the laser line projection on your Performax Saw is difficult to see, it could be due to bright light in the work area. Move the saw to a work area with proper lighting. Alternatively, sawdust on the laser lens may be the issue. Clean the laser lens with a soft, dry brush.
What to do if the cutting arm on my Performax 240-3688 won't raise?
If the cutting arm on your Performax Saw cannot fully raise or the blade guard cannot fully close, it may be due to parts failure or improper pivot spring replacement, in which case you should contact an authorized service center. Additionally, sawdust buildup can cause this issue, so clean and lubricate the moving parts.
Why does my Performax 240-3688 Saw brush spark excessively?
Excessive sparking from the brush of your Performax Saw when the switch is released indicates the brush may be worn or damaged. Replace the brushes, consulting the MAINTENANCE section for guidance.
Explanation of symbols and specific warnings for safe operation, including eye protection.
Guidelines for safe use of electrical power, avoiding shock and ensuring proper connections.
Instructions for safe use of the built-in laser, warning against direct eye exposure.
Critical safety rules tailored for operating miter saws, including guarding and workpiece handling.
Procedures for squaring the saw blade to the fence and table for accurate cuts.
Instructions for safely removing, installing, and servicing the saw blade.
Lists common problems with their causes and suggested corrective actions for the miter saw.
To Next Page
General