2. Start the engine and run the engine at “LOW IDLE”
for two minutes. Perform this procedure in order to
ensure that the lubrication system has oil and that
the oil filters are filled. Inspect the oil filter for oil
leaks.
3. Stop the engine and allow the oil to drain back to
the oil pan for a minimum of ten minutes.
Illustration 51 g01165836
(Y) “Min” mark. (X) “Max” mark.
4. Remove the engine oil level gauge in order to
check the oil level. Maintain the oil level between
the “MIN” and “MAX” marks on the engine oil level
gauge.
i02869394
Engine Oil and Filter - Change
(CG-4 Oil)
CG-4 engine oil may be used. If this grade of engine
oil is used a 250 hour service interval is required for
the engine oil and the engine oil filter.
i02503009
Engine Valve Lash - Inspect/
Adjust
This maintenance is recommended by Perkins as
part of a lubrication and preventive maintenance
schedule in order to help provide maximum engine
life.
NOTICE
Only qualified service personel should perform this
maintenance. Refer to the Service Manual or your au-
thorized Perkins dealer or your Perkins distributor for
the complete valve lash adjustment procedure.
Operation of Perkins engines with incorrect valve
lash can reduce engine efficiency, and also reduce
engine component life.
Ensure that the engine can not be started while
this maintenance is being performed. To help pre-
vent possible injury, do not use the starting motor
to turn the flywheel.
Hot engine components can cause burns. Allow
additional time for the engine to cool before
measuring/adjusting valve lash clearance.
Ensure that the engine is stopped before measuring
the valve lash. The engine valve lash can be
inspected and adjusted when the temperature of the
engine is hot or cold.
Refer to Systems Operation/Testing and Adjusting,
“Engine Valve Lash - Inspect/Adjust” for more
information.
88
SEBU8172-04
Maintenance Section
Engine Oil and Filter - Change
To Next Page
Loading...
