Need help?Do you have a question about the Perkins 1104E Series and is the answer not in the manual?
Procedure for replacing the Electronic Control Module (ECM) and associated steps.
Troubleshooting steps for an engine that is overheating.
Diagnosing why the engine cranks but fails to start.
Troubleshooting steps when the engine fails to crank at all.
Addresses erratic or intermittent signals from the throttle demand sensor no.2.
Troubleshoots software failure within the fuel injection pump.
Engine derating due to high coolant temperature.
Engine shutdown event due to low engine oil pressure.
Tests the electrical power supply circuits to the ECM and other components.
Tests the electrical circuit of the fuel injection pump for various faults.
To Next Page
General
