Illustration 68 g01306131
Typical example
3. By using a suitable tool, remove spin-on filter (1).
Ensure that any fluid is drained into a suitable
container.
Note: Do not fill the fuel filter with fuel. The fuel will
not be filtered and the fuel could be contaminated.
Contaminated fuel can damage your fuel system.
4. Install the new spin-on filter. Tighten the spin-on
filter by hand.
5. Open the fuel supply valve.
The fuel system will need to be primed after the new
filter is installed. Refer to this Operation and
Maintenance Manual, “Fuel System - Prime” for the
correct procedure.
In Line Fuel Filter
Illustration 69 g06524275
1. Close the fuel supply valve.
2. Clean the outside of fuel filter (3) and the fuel
hoses attached to the fuel filter.
3. Make temporary identification marks on the fuel
hoses to aid fuel filter installation. The direction of
fuel flow through the fuel filter is identified in
Position (A) on the fuel filter. Refer to illustration 69
.
4. Disconnect the fuel hoses from fuel inlet (1) and
fuel outlet (2) of the fuel filter.
Note: Do not fill the fuel filter with fuel. The fuel will
not be filtered and the fuel could be contaminated.
Contaminated fuel can damage your fuel system.
5. Install the new fuel filter to the fuel hoses. Ensure
that fuel inlet (1) and fuel outlet (2) are connected
in the correct orientation.
6. Secure the fuel hoses to fuel inlet (1) and fuel
outlet (2) with hose clamps.
7. Open the fuel supply valve.
86
SEBU8311-09
Maintenance Section
Fuel System Filter - Replace
To Next Page
Loading...
