Perlick HA24RB - Safety Information; Refrigerant HFC-134 a; Potential Problems with HFC-134 a; Service Manual Safety Labels

PERLICK RESIDENTIAL UNDERCOUNTER REFRIGERATION USE & CARE GUIDE
perlick customer service (800)558-5592 | 9
TOUCH-SCREEN CONTROL OPERATION - FREEZER MODELS
MAINTENANCE
SEASONAL MAINTENANCE FOR UL-APPROVED
OUTDOOR MODELS

Thisprocessshouldoccurwhenthedailylowtemperaturesisat
orbelowthetemperaturesstatedbelow:
Freezermodels:32°F
Refrigeratormodels:38°F
BeverageCenter:42°F
WineReserve:45°F
Itisbesttowinterizeyourunitbeforethelowtemperatures
listedabove.
1.TurntheunittoOFFposionbypressingtheOFFbuonon
thecontroller.Thecontrollerdisplaystheword“OFF” and,
forSignatureSeriesmodels,turnthemasterswitchlocated
behindthegrilleo(ifthepowercordisaccessible,unplug
the power cord. If not, turn o the circuit breaker to the
electricalreceptaclethecabinetispluggedinto).ForC-Series
units,unplugorturnothecircuitbreaker.
2.Removeallcontentsfromtheunit.
3.Removethefrontgrille.
4.Clean the condenser by using avacuumcleaner to remove
loose debris (leaves, dirt, etc.)that mayhaveaccumulated
insidethegrille.
5.Reinstallthefrontgrille.
6.Clean the interior of the unit using stainless steel cleaner and
polish(seepage9).
7.Cleantheexterioroftheunitusingstainlesssteelcleanerand
polish(seepage9).
NOTE: Do not place a cover over the unit. While not required,
you may choose to remove the unit from the outdoor locaon
and store indoors.



Thisprocessshouldoccuraerthedailylowtemperaturesis
abovethetemperaturesstatedbelow:
Freezermodels:32°F
Refrigeratormodels:38°F
BeverageCenter:42°F
WineReserve:45°F
1.Removethegrille.
2.Checkthecondensingunittoensureitisclearofloosedebris,
andcleanasnecessarywithavacuumcleaner.
3.Reaachfrontgrilletotheunit.
4.Clean the interior of the unit using stainless steel cleaner and
polish(seepage9).
5.Cleantheexterioroftheunitusingstainlesssteelcleanerand
polish(seepage9).
6.Plug the unit into the electrical receptacle or turn on the
circuitbreaker.
7.Turnonthemasterswitchlocatedbehindthegrilleifmodel
is Signature Series. Press the OFF buon one me to turn
the unit on. The controller display will show the actual
temperatureinsidethecabinet.
8.The cooling process will begin to bring the unit to the set
temperature.It’srecommendedyouruntheunitfor24hours
tostabilizetheoperangtemperaturebeforeusing.

  


CallyourPerlickFactoryAuthorizedServiceCenter.Forthe
locaonoftheServiceCenterinyourarea,contactyourselling
dealer,inquireviathewebatwww.perlick.com,E-mailusat
warrantyserv@perlick.com,orcall(800)558-5592during
normalbusinesshours.


Toreplaceadefecveorburntoutbulb,removetheglasslight
coverbypullingoutonthecover,unscrewthebulbandreplace
itwithanidencalorsmallerbulb.ThePerlickreplacement
partnumberis63716-1.
DANGER!
CAUTION!