Perrot Water Control+ SC - Setting Sensor Monitoring Time


TDP072d+e.doc Rev.07.07.2015 Seite‐Page53/64
PerrotREGNERBAUCALWGmbHIndustriestraße19‐29/D‐75382Althengstett/Germany
Telefon:0049‐7051‐162‐0/Fax:0049‐7051‐162–133
E‐mail:perrot@perrot.de/E‐mailKonstruktion:technik@perrot.de
 Press and toselect„Sensorafterruntimes“

Press toconfirm.

 Toselectastation,press and ,thenchooserightorleftside.
 Use or tosetsensorafterruntime.
 Sensorafterruntimemaybeadjustedfrom0‐15seconds.Factorysetting:5seconds.
 Press tosavechangesandreturntopreviousmenu.
 Adjustmentrange:0‐15sec.
 Factorysetting:5sec.


Sensortime
Thesensortimeisusedformonitoring.Ifthecontrollerdoesnotreceiveanysignalfromanactive
SC‐stationduringthetimeset,itwillstopthisstationandcontinuewiththenextstation.

 Use
and to select„Sensortime“
 Use
or toincrease/decreasetheselecteddigitandpress tosavechanges
Adjustmentrange:  60–150seconds
Factorysetting: 90seconds

