35
EN
5 - ISTRUZIONI D’USO
5 - PROGRAMMABLE FUNCTIONS
Mode
OK
Mode
OK
Mode
OK
Mode
OK
Mode
OK
5.7 - PROPORTIONAL CYCLE DURATION
The duration of the control cycle for the PROPORTIONAL mode
( can be set from to minutes. A long cycle is
recommended for systems with high thermal inertia (cast iron
radiators, floor systems) and a short cycle for systems with low
thermal inertia (fan coils). The default setting is minutes.
)720
10
Set the duration of the
proportional control cycle
via the or button.
Press to save and move
on to the subsequent
setting or keep the button
pressed for at least 4 sec to
save the new setting and
exit the programming
menu.
OK
5.8 - ADJUSTING OR EXCLUDING THE ANTI-FREEZE PROTECTION
When set to the mode, the thermostat is set to protect the system
in the event of frost, when the temperature falls below +4.0 °C; this
setting can be adjusted from +4.0 °C to +12.0 °C. This function can
also be excluded. In this case, the system will be exposed to possible
damages caused by frost.
If on the other hand you
wish to exclude the anti-
freeze protection, press
the or button until
appears on the
display and confirm via
the button as
described above.
OK
Set the desired anti-
freeze temperature via
the or button.
1°
2°
Mode
OK
Press to save and
move on to the subsequent
setting or keep the button
pressed for at least 4 sec to
save the new setting and
exit the programming
menu.
OK
To Next Page
Loading...
